网上棋牌

Welcome to the official website of Wuxi Tonghui Steel Grating Co., Ltd.!

13951500039

20 years of experience in the steel grating industry



Switchboard: 86-510-83887016

Fax: 86-510-83887036

   13951500039 Contact: Mr. Li 13951500039

   Email: 13951500039@126.com

   Address: Qibei Road, Yuqi Supporting Zone, Huishan Economic Development Zone, Wuxi City



Mounting clip
HomeProductsMounting Clip 〉 Mounting Clip

There are two methods of fixing the steel grid plate: welding and installation. 1. For permanent without disassembly, you can use welding to weld it to the support. For the specific position, weld on the first flat steel in each corner of the plate. Fillet welding with a length of not less than 20 mm and a height of not less than 3 mm.
2.The use of mounting clips has the advantages of not destroying the zinc layer and easy disassembly. It can be fixed with mounting clips. At least four mounting clips should be used for each plate. It is best to install a few more on the available support for larger plates Each.

Type A: It consists of an upper pressure plate with double hooks, a lower pressure plate with teeth and an M10 (or MB) hexagon socket bolt.
Type B: an upper pressure plate with double hooks (one of which can surround two adjacent steel grid plates together), a lower pressure plate with teeth and one
M10 (or M8) inner corner bolts.
Type C: It consists of an upper pressure plate with double hooks and an M10 (or M8) hex head bolt that can be welded to the support member.

There are two methods of fixing the steel grid plate: welding and installation. 1. For permanent without disassembly, you can use welding to weld it to the support. For the specific position, weld on the first flat steel in each corner of the plate. Fillet welding with a length of not less than 20 mm and a height of not less than 3 mm.
2.The use of mounting clips has the advantages of not destroying the zinc layer and easy disassembly. It can be fixed with mounting clips. At least four mounting clips should be used for each plate. It is best to install a few more on the available support for larger plates. Each.

Type A: It consists of an upper pressure plate with double hooks, a lower pressure plate with teeth and an M10 (or MB) hexagon socket bolt.
Type B: an upper pressure plate with double hooks (one of which can surround two adjacent steel grid plates together), a lower pressure plate with teeth and one
M10 (or M8) inner corner bolts.
Type C: It consists of an upper pressure plate with double hooks and an M10 (or M8) hex head bolt that can be welded to the support member.

News Center Application Cases Honor Customer Service Support Ordering Instructions Common Problems Expertise Contact Us